BIG POWER FOR YOUR CAR BUT AT A "BUDGET" PRICE!
Over the years, we have built literally hundreds of 2.5 engines for clients. We always knew there was a good market for a slightly lower "entry level" build for those folks that wanted a quality built engine with all the good features but designed with your wallet in mind. To this end, we stepped up and had our own forged stock length rods built and found a good source for a high quality alloy high compression piston.
So now you can have a high quality, high compression engine for your street/track car at a desirable price point!
Low hour core engines are completely stripped, ultrasonic cleaned, inspected and assembled with high quality parts;
PISTON SET, 11.5:1 1 GOAL
ROD SET 1 GOAL H BEAM
BALANCER BOLT OE
FLYWHEEL BOLT OE
CAM BOLT OE
HEAD BOLT SET OE
ROD BEARINGS ACL
MAIN
BEARING SET KING
REAR SEAL OE
GASKET HEAD APEX
CAMS BC
VALVE SPRING SET BC S
CHAIN TIMING OE
TENSIONER OE
CHAIN RAIL OE
CHAIN GUIDE OE
Short Blocks are completely machined;
Deck resurface to true
Cylinder hone to finish
Cylinder heads are completely machined;
Deck surfaced to true
Camshaft bore inspected
New guides as required
New Ford valve stem seals
Pressure tested
Our 3 angle valve job, and hand lap
Engine assemblies are then assembled, in house, to our specs.
Street use engines come with a 12 month/12 thousand mile warranty.
There is a 650.00 core charge fully refundable for oil pan and valve cover assemblies.
Each engine is provided complete with a build sheet and dyno sheet and comes with base tuning for the factory ECU( you must have the Ecutek hardware and license)
PLEASE NOTE** Engines are custom built to order. Build time is 3-4 weeks depending on work load
